Post by sam on May 12, 2017 5:11:53 GMT
In the regulations it states:
I'm not sure if I fully understand that rule.
Also is this regulation strictly enforced? If the brace is attached to the roll bar greater than 200mm from its top, would it still be acceptable if its sufficiently strong?
Thanks.
At least one triangulated brace must be fitted to the rear roll bar.
This brace should attach to the chassis of the vehicle at one end, to not more than 200mm from the top of the roll bar at the other, and must be capable of taking forward and rearward loadings.
This brace should attach to the chassis of the vehicle at one end, to not more than 200mm from the top of the roll bar at the other, and must be capable of taking forward and rearward loadings.
Also is this regulation strictly enforced? If the brace is attached to the roll bar greater than 200mm from its top, would it still be acceptable if its sufficiently strong?
Thanks.
